Post by grundlepunch on Dec 11, 2007 9:40:41 GMT -5
i have a front chevy 44.
the axle is full width (not sure of wms-wms) pass side drop, low pinion, unknown gears.
the good stuff off it:
- flat top knuckles, driver side is drilled and tapped. (will fit on any front 44)
- small bearing spindles, 6 bolt mounting (good conversion for waggy fronts to run 5x5.5")
- disk breaks and mounting plates (also god for converting)
make an offer if you need anything. - Dana
the axle is full width (not sure of wms-wms) pass side drop, low pinion, unknown gears.
the good stuff off it:
- flat top knuckles, driver side is drilled and tapped. (will fit on any front 44)
- small bearing spindles, 6 bolt mounting (good conversion for waggy fronts to run 5x5.5")
- disk breaks and mounting plates (also god for converting)
make an offer if you need anything. - Dana