Post by 1cleantj on Feb 2, 2008 1:25:20 GMT -5
what ton hydraulic tube bender would be good for general tube bending (1"-2" tubing up to about 1/8" wall) ?
what type of setup do you use ?
any what size mig welder would be good for plate up to about 3/16's ?
I have a smaller 90amp flux core mig welder right now, it does ok for sheetmetal/exhaust work but doesnt penetrate great on thicker stuff and leaves alot of splatter (looking to get a gas shielded welder). Not looking to break the bank either cost wise.
post's your opinions /setups !
what type of setup do you use ?
any what size mig welder would be good for plate up to about 3/16's ?
I have a smaller 90amp flux core mig welder right now, it does ok for sheetmetal/exhaust work but doesnt penetrate great on thicker stuff and leaves alot of splatter (looking to get a gas shielded welder). Not looking to break the bank either cost wise.
post's your opinions /setups !
