good old power window problem

[fro-nig]

ok, so i have the good old power window problem in my new xj.
i am able to put down ONLY my drivers window. i cannot control any of the passenger windows, not even from the drivers side controls.
i did the jumper trick to override the lockout control but that didnt do anything (yes i jumped the correct 2 wires, i followed the directions and pictures)

everyone that i have seen that has had a problem has at least been able to put down all the windows from the drivers side control, but mine doesnt do anything. i think thats why the jumper trick worked for them, but i have yet to find anyone else that has the same problem i do.

any of you guys have any ideas on what else i could do??

[HeavyMetal]

im really not sure other than the motor...perhaps one of the fuses is blown? check out the fuse panel

[fro-nig]

yeah i checked all the fuses first. everything was fine there. a guy over at jf.com said one of the wires goin from the drivers side to the passenger side must be broken. i am headed out to the garage now with my tester. hopefully i will figure this darn thing out

[Buffalo Phil]

just take off the doors and never have to deal with windows again.

O wait. you have post '97 door hinges.

[HeavyMetal]

therifleman said:

just take off the doors and never have to deal with windows again.

O wait. you have post '97 door hinges.

xjfanatic.com/97doorless.php

[Buffalo Phil]

I'd rather have the pre-97. Easier to remove with dremel, railroad spike and hammer.

[spanky]

im sure ur dads shop would find the pre97 hinges easier to cut off

[Buffalo Phil]

Anything comes off with a sawzall.

[Queery Adams]

including your bumpstops hahahahah

[Buffalo Phil]

Haha. As of 20 minutes ago they are back on.

[spanky]

u use mine? the ones i gave u?

[fro-nig]

u guys are frikin funny.

well i took apart all the door and did a whole bunch of continuity tests and i figured something out........i am even more confused now then before i took em apart. but i do know that the passenger doors are not getting power to their switches/windows