Post by XJLI on Jan 8, 2009 16:48:34 GMT -5
Old style, used. one has a tiny kink in it, barely noticeable. I thought these were loose causing my vibes... turns out both my front axle u joints need to be replaced. Anyway, I just put new races in these when I got them last year, so the SF joint is nice and tight, but one of the superflex balls is wallowed out a tiny amount, maybe a 1/16 of an inch more than the almost new ones I just installed. They dont look too pretty, since I painted rustoleum hammered over the disappearing grey powedercoat, and the rubber bushings could use replacing eventually (same as factory ones), but will work for a while. They looked the same now as they did when I put them in.
If you want rebuild them to new, its pretty cheap. You need 4 races, so two RM13640, four snap rings HW5015, and two superflex balls 13630. The frame side are factory replacement rubber LCA bushings.
They'll work as-is just fine.
$70 shipped to any SiS member, $80 shipped to anyone else. I'll snap pics later.
If you want rebuild them to new, its pretty cheap. You need 4 races, so two RM13640, four snap rings HW5015, and two superflex balls 13630. The frame side are factory replacement rubber LCA bushings.
They'll work as-is just fine.
$70 shipped to any SiS member, $80 shipped to anyone else. I'll snap pics later.
